In 안에 Part 10 제 10 회 , Bennett had finished breaking up the poured concrete floor as part of repairing the floor of the new shower that was part of our home renovation just 9 months ago. , 베넷 공부가 다 파괴의 일환으로 수리를 부어 바닥에 콘크리트 바닥의 새로운 샤워의 일부가 단지 9 개월 전에 처음으로 개조합니다.
Even before the pieces of concrete were removed from the shower floor, one of the causes of the leak were revealed. 심지어에서 제거하기 전에는 샤워, 그 조각들은 콘크리트 바닥의 누수의 원인 중 하나는 공개합니다.
In fact, even before any of the concrete shower floor was broken up, the second cause of the leak was revealed. 사실, 심지어 샤워하기 전에 콘크리트 바닥은 오래전에 깨진 중 하나를, 두 번째 원인은 누수 밝혀졌다.
Now, cause #1 was the improper drain which we have already discussed. 지금, 원인 # 1은 부적 절한 유출을 우리는 이미 논의합니다.
Cause #2 was revealed only when Bennett had removed part of the wall tile at the base of the shower floor. 베넷 경우에만 원인 # 2 밝혀졌다 벽의 일부가 제거됩니다 타일 바닥의 바닥에 샤워합니다.
The approach taken when the shower was first built was to put the shower tiles first on the ceiling and then on the walls of the shower. 샤워가 건설될 때 그 접근 방식은 샤워를 놓습니다 타일 천장에 먼저 샤워를하고 다음을 벽에합니다. The shower floor was last. 샤워 바닥이 마지막으로합니다. Per Bennett, this was not correct. 1 베넷, 이것은 올바르지 않습니다. What should have occurred was to build the shower floor first, including the floor tile, and then tile the shower ceiling and walls. 어떻게해야 샤워를 작성하는가 바닥이 발생했을 첫째로, 바닥 타일을 포함하여을 입력한 다음, 벽 천장 타일 샤워합니다. Why? 왜?
Well, you want to have the shower floor tiles underneath the wall tiles. 글쎄, 당신은 샤워를 아래에있는 바닥 타일 벽 타일합니다. this is so when water from the shower rolls down the wall tile it will reach the floor tile directly. And, with a properly sloped floor that is sloped in all areas of the floor towards the drain, the natural path for the water will be to go towards the drain, even if there is insufficient silicone caulking at the point where the floor and ceiling tiles meet. 이것은 그래서 아래에서 물이 나와 샤워 롤 벽 타일이 바닥에 타일을 직접 도달합니다.하고 적절하게 경사에 경사가 모든 영역에서 바닥을 향해 바닥에 배수를 할 자연적인 경로를 물 유출을 향해 이동하더라도 시점에서 코킹 실리콘이 부족 바닥, 천정 타일 어디 충족합니다.
However, in this case, with the wall tiles installed before the floor tiles, when water from the shower came down the walls it did not meet the floor tile; rather, if there was any gap in the silicone caulking between the wall and floor tiles the water would have done through the opening and into the grout. 그러나,이 경우에는 바닥에 타일을 설치하기 전에 벽의 타일 때, 샤워실에서 나온 물이 벽이 몰려왔다 요건에 맞지 않아 바닥 타일; 오히려, 어떤 차이가 있었다면 벽과 바닥에 타일 사이의 실리콘 코킹 물이했을를 열고 주입을 통해합니다. Grout is pores and eventually water would have gone through the grout and onto the concrete sub-floor. 시멘트는 물했을 숨구멍을 통해 그리고, 결국 시멘트 및 방면의 구체적인 서브 - 층합니다. This is what happened to make the concrete under the floor tiles by the time Bennett broke it up into pieces damp around the far wall and the wall on the left. 이것은 무슨 일이 있었을 때 즈음의 구체적인 베넷 아래의 바닥 타일 조각을 망가 뜨 멀리 벽 주변에 물기가 왼쪽에있는 벽.
Now, even in this case the leaking water should have been retained by the rubber water proofing mat underneath the concrete floor. 지금,이 경우에도 새는 물 보존을 했어야 아래의 콘크리트 바닥이 고무 방수 매트합니다. That is what it is supposed to do. 해야 할 것이 무엇이있습니다.
Once Bennett had finished breaking up the concrete he uncovered a small hole in the rubber water proofing mat. 한 번 헤어지는 베넷의 구체적인 공부가 다 그 작은 구멍을 발견 고무 방수 매트합니다. Was this caused by the drilling of the concrete floor. 이로 인해 콘크리트 바닥에이 있다고 생각합니다. Per Bennett, no. 1 베넷, 아니합니다.
Even if the hole was made by the drilling, once the broken concrete was removed, we found what we think is the primary reason why water that found it’s way onto the water proofing mat found it’s way out of the shower and into our basement. 이 있다고 생각 의해 만들어진 구멍을 경우에도, 일단 깨진 콘크리트가 삭제를 발견 물 우리가 생각하는 주요 이유는 그것이 발견 물의 방식을 교정 매트 밖으로 발견의 방식으로 샤워도하고 우리의 지하합니다. That’s for next time. 저것은 다음 번에합니다.




























