Finished Pivot Toilet Paper Holder Intallation

So far in this how-to series, we looked at the installation of the Moen Branbury Pivoting Toilet Paper Holder with the brushed nickel finish which we purchased at The Home Depot as part of its Renew and Redo Your Bath event and began the installation.

Today we get the new bathroom accessory installed into the potty room of our en suite.

Now, here once again are the different parts from the packaging which one uses to install either end of the toilet paper holder.

Toilet Paper Holder Installation Materials Finished Pivot Toilet Paper Holder Intallation

For us, we only needed one pair of the butter fly anchors. Why? Well, as fortune would have it the end on the right in the picture below was right in line with a vertical wooded stud. So, for that end we simply drilled guide holes into the wood stud and directly inserted the screws.

Installing Toilet Paper Holder Anchors Finished Pivot Toilet Paper Holder Intallation

It was the pair of holes from the original toilet paper holder that we used a pair of the butterfly anchors. Notice in the above picture that the red plastic pin seems to be sticking out from one of the anchors. This is the before picture. You gently but firmly use a small hammer to tap on the red pin to cause it to push open the ends of the butterfly anchor on the inside of the drywall.

Installing Butterfly Anchors Into Drywall Finished Pivot Toilet Paper Holder Intallation

In this next picture above you can see (hopefully) that the red pin is further into the opening of the top butterfly anchor indicating that it has does its job.

Once both drywall anchors are in place, then the anchor bracket is screwed into the anchors.

Holder Anchors In Place Finished Pivot Toilet Paper Holder Intallation

And now each of the two pivoting toilet paper holder ends are installed onto the anchors.

Right Side Of Toilet Paper Holder Installed Finished Pivot Toilet Paper Holder Intallation

First the  right side of the pivoting toilet paper holder is installed using the provided Allen key to insert the very small screw within the bottom of the end to hold it securely onto the wall anchor.

Both Sides of Holder Installed Finished Pivot Toilet Paper Holder Intallation

Then the other side is installed in the same manner.

Pivot Toilet Paper Holder Installed in Bathroom Finished Pivot Toilet Paper Holder Intallation

And, just like that we have the Moen Branbury Pivoting Toilet Paper Holder installed on the bathroom wall by the toilet.

Toilet Paper Roll on Pivot Holder Finished Pivot Toilet Paper Holder Intallation

Now, of course I am not finished. I need to address the two small holes in the wall just inside the end on the right from the previous toilet paper holder. I will address those next time.

Moen Pivoting Toilet Paper Holder Ready For Use Finished Pivot Toilet Paper Holder Intallation

To continue, select this link to where we start to repair the small drywall holes caused by the toilet paper holder replacement.

NOTE: The Home Depot works with bloggers such as myself to conduct product reviews. They do not tell bloggers what to say about their products or how to say it. The Home Depot fundamentally believes that people should be free to form their own opinions and share them in their own words. The Home Depot often provides product – free of charge – to bloggers for review as they did for this post. The Home Depot’s policies align with WOMMA Ethics Code, FTC guidelines and social media engagement recommendations.

Suggested Articles For You:

share save 171 16 Finished Pivot Toilet Paper Holder Intallation

Speak Your Mind

*


*

Featuring Recent Posts WordPress Widget development by YD